2018
October
- 30: Brief Discussion: Should Bolting Preload be included in a Finite Element Analysis?
- 30: When do Flanges need to be Registered?
- 30: What are the Quality Management System requirements for a fabricator of Pressure Piping to be installed in Alberta?
- 30: How can a CRN be obtained for Sanitary Tri-Clamp?
- 30: Registering Flanges Conforming to SAE J518 Standard
- 26: Discussion: Finite Element Analysis (FEA) in a CRN Submission
- 26: TSSA: Code Adoption
- 26: Is a CRN Required for Hose at ABSA?
- 26: Key Design Engineering ABSA Pressure Piping Quick-Guide:
- 26: Appendix-2 Flange Rigidity per 2008 Addenda:
- 26: What Is An Appendix-Y Flange?
- 25: Weld Failure, Investigation and Analysis
- 25: Quartz-Sleeve Wiper:
- 25: Lamp Connector: High-Flow Water Treatment System
- 25: Lamp Connector – Lower Flow Reactor
- 25: Patent, UV Lamp Support
- 25: Butterfly Valves, Category C Fittings
- 25: Piping Skid Registrations, ASME B31.3
- 25: Piping Calculations, ASME B31.3
- 25: New Steam Cooker, CRN for British Columbia
- 25: Used Steam Cooker CRN for Ontario
- 25: Air Receiver ASME VIII-1
- 25: Filter Vessel ASME VIII-1
- 25: Refurbished Autoclave ASME VIII-1
- 24: Fatigue Calculation
- 24: Cyclic Loading
- 24: Certain Joint Configurations for the Attachment of Welded Unstayed Flat Heads
- 24: Tri-Clamp Sanitary Fitting
- 24: What is FEA?
- 24: Fitting Categories
- 23: When is a CRN Required?
- 23: The CRN (Canadian Registration Number).